Minitor V circuit board replacement

This guide will show you how to replace the Motorola Minitor V circuit boards. Warning: We provide no technical support beyond this web page. If you attempt this procedure we will not assist you in any way, either on the phone or by e-mail. Proceed at your own risk!
The first step is to remove the a small amount of clear adhesive that holds the charging contacts in place. Use a small tool to scrape off the adhesive to break the bond between the housing and the connector.
Remove the charging contacts from the center housing. Be careful not to pull too hard or you will damage the ribbon connector.
The audio jack protrudes into a hole in the center housing. To remove the audio jack, pull on the plastic center housing enough to deform the plastic and release the jack.
The decoder board will now easily side out of the housing. Avoid turning the knobs to allow easier re-assembly.
Pull the switch board straight up in a rocking motion to remove it from the decoder board. Warning: We provide no technical support beyond this web page. If you attempt this procedure we will not assist you in any way, either on the phone or by e-mail. Proceed at your own risk!