Venus, FL USA
800-822-2180
You are here: Skip Navigation LinksHome > Minitor information > Minitor V programming
P&W Service Center
18442 County Rd 731
Venus, FL 33960
Phone:
800-822-2180 (USA only)
Fax: 941-360-2207
e-mail: sales@pwservice.com
web: www.pwservice.com
Hours:
Weekdays 9:30AM - 4:30PM EST
(Closed on major holidays)

This is a guide to program Motorola Minitor V (5) pagers.

To program a Minitor V pager you will need the hardware and software. Buy it Now

Download the Motorola Minitor V programming softwareNew Window

Download the Motorola programming manual New Window

The first thing to do is place the pager into programming mode.

  1. Insert a good battery into the Minitor V pager and turn the pager off
  2. Change the switch position to "C"
  3. Hold down the reset button then turn the pager on while holding the button down
  4. Release the reset switch. You should hear a continuous beep for 3 seconds
  5. The Minitor V pager is now in programming mode
Next read the Minitor V pager. If you were successful you will see the following.

The "red text" are our comments.
Minitor V pager software

At the top click on "Channel F1" this will bring you to the second tab shown below.

This is where you enter the Minitor 5 frequency and paging tones. If you have a two channel pager, select "Channel F2" (not shown) to enter frequency 2 information.
Motorola Minitor V pager tones programmed

The 3rd tab has the Minitor V programming options. We recommend the settings shown below.
Minitor V programming options

The 4th tab sets the Minitor V switch settings.
Minitor V pager knob settings